Connect Surface to External Display

The obvious answer seems to be HDMI. The answer is more complex than you might think. It has some obvious advantages. It carries both audio and video. The problem is that many projectors are located quite far from the computer. The tech booth is two feet off the floor. That means you need to run the cable six feet to the back wall, up thirteen feet, forward thirty, and finally down six feet to the projector. You need to run the cable twenty-three feet longer, almost twice as long.

How to Set the Monitor for a Remote Desktop Session in a Multi-Monitor Setup

This article shows you how to configure a saved remote desktop connection so that sessions to a particular computer always appear on the monitor that you choose. In Windows 7, Default. You can edit this file by right clicking it and selecting Edit. The Remote Desktop Connection dialog that appears has a Display tab.

Jan 27,  · I’m trying to decide whether I should get a Mac pro or the 5k. I’d like to set up three monitors. So three with the pro or two more onto the 5k.

I removed the extra black pin but this is not necessary 3. Connect the molex male end to the female molex of your power source which should be OFF 4. I have two attached in the pic but you only need one – Attach Black Alligator wire to one black molex wire – Attach Two Red Alligator wires to red molex wires but on 1 wire attach sideways leaving end exposed for a second wire as seen in picture. Using Green simply helps telling the wires apart. Alligator Wires to Molex yellow is out of frame 5.

Purple does not appear to be necessary Resistors wrapped around Green and Purple pins 6. Connect your alligator wires to the inverter pins – Connect Yellow to Blue pin – Connect either Red to Red – Connect the other Red to the resistor wrapper around the Purple pin Does Not appear to be necessary – Can leave floating – Connect Green to the resistor wrapped around the Green pin – Connect Black to the Black pin – Orange or White depending on neck inverter wire is not connected and left floating.

Turn on your power source. The backlights should come on as seen below. If so, turn off the power and continue on. If not check your connections. The backlights on IV:

Can I hook up my macbook to a new iMac and use the iMac as an external monitor?

This is one of the most important considerations when shopping for an audio interface. There are a wide variety of different options available. At the other end of the scale, there are larger interface systems that can handle dozens—even hundreds—of channels and many inputs simultaneously.

Note for VSL users: If you have an AudioBox 44VSL or AudioBoxVSL, you will see multiple devices for the AudioBox, including Line Out 1/2, Line Out 3/4, etc. Select Line Out 1/2 to set the main output as the default device for Windows.

Not to mention, unlike Apple or Android tablets, it can run actual PowerPoint. Hopefully this way, you can concentrate on your presentation instead of fighting with the displays. Video Port on Surface RT vs. Also, it will be helpful if you have a keyboard and mouse. This is because the easiest way to switch between multiple display modes requires a keyboard. Unfortunately, this means that you can accidentally plug your adapter in upside-down. This is where having a keyboard is really handy.

Just follow the instructions below: From here you have the following choices: This option ignores the second display.

Computer Monitor, LCD, and Display Help and Support

Step One First of all, you need to identify what sort of Mac you have. This means that typically both plugs and sockets on monitors and cables will be these colours. Luckily, Apple have already thought of this, and carry a whole range of said adaptors. UK link — US link Old and new adaptor. Macs have a tendency to do that.

Set up PowerPoint to use Presenter view with two monitors On the Slide Show tab, in the Monitors group, select Use Presenter View. Windows Display Settings should open.

Thanks for your many years of attention and everything you’ve done to make the site such a valuable resource. The first thing is that you have to do some configuring of both Java and Safari to get the applet to run at all. Once that was all done, I could log in from all my Macs, fire up the applet and establish a secure connection.

On two of the Macs, as soon as I fired up the Citrix app, the Java vpn window would show ‘error’. The console showed a Java crash. But on the third Mac, everything worked fine. I made sure that the Safari and Java preferences were set the same on each machine but still no joy. Then I remembered that I had done some Java development in the past and installed various jdks from Oracle so I ran:

Today’s Stock Market News & Analysis

The big decision Should you upgrade to the new iMac Pro? The iMac Pro goes on sale December Your average iMac owner may not need this power, but do you, dear reader? Let’s go over the reasons why you should or shouldn’t upgrade to Apple’s newest professional machine.

I have now started using lightroom but am on the old version and can’t find a way to work across two screens:(I have done a lot of reading about monitors and believe there are better ones out there for colour critical work but for now I am happy with my set up and can’t afford to change it just yet.

Darko December 29, , My latest rig flew as a single piece of checked baggage from Hong Kong to Australia and then to the UK before being couriered to Germany. This is the LS50 but not as we know it. Jack Ocklee-Brown and his team of Kent-based engineers have activated this super-popular standmount with bespoke fit amplification, DAC and network streamer and installed the whole lot inside the speaker enclosures.

Inside each speaker sit two amplifiers and two DACs. Cast a casual eye over any audio show coverage: And how many rooms feature active loudspeakers? Yup — thought so. This 21st Century hifi system comes to life with a four-note start-up sound and we are ready to play music in under five minutes.

How do i connect xbox one to my iMac?

I have been using more than one monitor on my computer for years. Once I read that Windows could indeed handle more than one video card, the light bulbs went off. I can have more than one screen? I shortly went out and purchased a second screen. When I switched to the Mac Pro back in October, the system came with a single video card with two video outs. But, I had more than two monitors.

Rated 5 out of 5 by soopabox from nice and wide! consistent color I am not a gamer, but I do like alot of screen space, especially for my stock market chart program. This monitor gives me space for 4 more charts to be on the screen with the others/5().

There are two dual-screen “modes” that Mac OS X supports: You’ll have two docks and two menubars — and whatever you do on one monitor is “mirrored” on the second monitor. This is what I suspect you have it set up as right now, since in mirrored mode, both monitors are forced into the same resolution. A typical 17″ monitor like your iMac supports a native resolution of x , so your iMac’s monitor is being “mirrored” onto the second monitor, resolution and everything.

In this mode, you only have one menubar and one dock on one monitor, and the second monitor is simply an extension of the first. You can open a window on the first monitor, then drag it across to the second monitor — like having one, large monitor instead of two independent monitors. In this situation, each monitor can have independent resolutions.

Check to ensure that you’re using “Extended desktop” mode instead of mirroring. This Apple support article is quite dated, but still applies although the configuration options may be slightly different due to the age of this support article:

Can I connect my MacBook Pro to 2 external monitors?

Computers How to set up multiple monitors with your Mac With just a few minutes of your time and the appropriate accessories, you can connect an extra display to your Mac and increase your productivity. We’ll talk performance upgrades for old and new models , hardware hacks, and workflow tips. This is where you’ll go to find out how to release your Mac’s potential and make the most of your purchase.

When setting up the sub, whenever possible use an SPL meter and test signals (tones/noise) to dial up a a sub level that matches the level of the lowest frequencies of the main speakers (an octave or two higher), insuring as even (flat) a response as possible all the way down to .

At first, I thought it was awesome and would help me organize my screen and my day. After a week or two, however, I felt myself using the second monitor just for the sake of using it. At the end of the day, I decided that using one monitor is easier, and makes me more productive. At first, I used the second monitor just for email, so I could work on the other screen. Having email open all the time is the ultimate attention diverter.

At time I felt like I was watching paint dry, just waiting for another email to come in. Big waste of time. That was nice and convenient, but again, a big attention waster and a waste of a monitor. Using the two monitors to view two documents was not all that helpful either.

How to Connect a Mac to a Projector

The search for a cheaper option, most often a high-end calibrated computer monitor or high end television, used in place of a relatively expensive, purpose-built, professional colour grading monitor, still remains a holy grail quest, of sorts. In this post my aim is to dip a toe in the water, share some expert opinions not my own , present a case for and against, and suggest some possible solutions. Along with a bucket load of caveats.

On my 24inch iMac the screen has a problem (dead pixels) and I will get it replaced in the future, in the mean time I have a very nice large external monitor connected to the iMac which I use ok, what I am looking for is a way at first when booting up, to be able to see both the iMac’s screen and the external monitors screen, then some.

And unlike what is suggested in the Lenovo article referred to, it is NOT necessary to be running in “Optimus mode”. You can in fact be running in “discrete graphics” mode to accomplish this just as well. I don’t own a dock, but can run three screens in the basic non-dock 3-monitor configuration using the laptop screen and two external monitors connected directly to the W One monitor is plugged into the miniDP connector, and the other monitor is plugged into the VGA connector.

Note that in “discrete graphics” mode, you can install the standard retail nVidia graphics driver latest one for K M is I do not use the Lenovo-provided Optimus driver which includes back-level old nVidia driver along with Intel graphics driver.

How To Connect Multiple Monitors to MacBook Pro / Air